The DCS-8300 offers you both easy operation part of an analog
oscilloscope and high functionality part of a digital oscilloscope. As
it employs high-intensity CRT high-speed single event can be observed
easily.

The DCS-8300 has a variety of trigger functions to catch many different
waveform. It also has a 40 MS/s AD converter in each channel and a maximum
sampling speed of 100MS/s is achieved in 1 channel mode. A large capacity
of 16K words memory for each channel makes long-term record storage possible.
For front panel settings up to 100 steps can be stored丆 which enables
recall of frequently used settings丆 etc. by a touch of a button. A selection
of optional interface (GP-IB or RS-232C) is also available. When these
options are used丆 the DCS-8300 can be controlled by PC丆 or waveform data
can be stored in PC.

100 MS/s (1CH) High-speed sampling
When the DCS-8300 is used by the 1 channel mode, high-speed sampling at
100 MS/s is available. It is possible the measurement of high speed events.
The highest sampling rate by 2 channel mode is 40 MS/s.

Large capacity 16K words memory
16K words of acquisition memory and 2K words of reference memory are provided
for each channel.
TV line counter
For television signal synchro-nization, a line counter is also provided.
By selecting the frame line number to be checked, the required line number
can be observed.

Parameter Auto Measurement Function
It is possible to measure the voltage, frequency and period automatically
just input the signal. Especially for voltage measurement, measurement
mode is automatically selected according to the input selector. For example,
when the AC input is selected, "Peak-to-Peak" voltage is automatically
measured, and when the DC input is selected, DC voltage is measured automatically.


Automatic setup function
By pressing the AUTO SET key, setup operations for the voltage range and
time range are automatically performed.

Pre-trigger
Observation of the waveform before the triggered point is possible. A
maximum of 80 div. before triggering point can be observed.

Overwrite function
In this mode, the waveform of a signal subsequently input is displayed
without erasing the currently displaying waveform. With this function,
it is easy to observe the jitter component or amplitude fluctuation of
the waveform.

[Single roll]
Setting "Single" in the roll mode enters the single roll mode. When the
trigger signal is input at this mode, the displayed waveform freezed after
the data corresponding to the value set for pre-triggering has been updated.


?% accuracy
In order to obtain highly accurate measurements, both the voltage axis
(except for 1mV, 2mV range) and the time axis ensure ?% accuracy. (under
ambient conditions of 10 to 35癈 temperature and less than 85% humidity)


100-Step Programming
The DCS-8300 provided 100 steps programming capability for store/re-call
operations for the front panel setting values. When the frequently used
panel settings are previously programmed, they can be recalled with a
touch of a button. This function greatly reduces the time required for
measurements.

Options
When the optional GP-IB or RS-232C interface is installed, the DCS-8300
can be controlled by external controller. It is possible the control of
the DCS-8300 from an external PC or stores the waveform data into the
PC.

SPECIFICATIONS